Schreiber-chillers MC75WC Bedienungsanleitung

MC75 - WC TABLE OF CONTENTS Model...

MC75 - WC MAINTENANCE - PART I 1. Maintenance to mold controller: þ Flush out water reservoir as needed. Do not allow this unit to run with

MC75 - WC MAINTENANCE - PART II FLUSHING OUT WATER COOLED MOLD CONTROLLER You will from time to time need to flush out the water cooling sys

MC75 - WC PARTS LIST MC75-WC – 460/3 or 230/3 If this unit has special feature(s) installed, see appendix for part number(s). Part Number Descript

MC75 - WC 14 Schreiber Limited Warranty Schreiber warrants the product described herein against defective material or workmanship for o

MC75 - WC SAFETY SUMMARY In this Manual: DANGER means that you will be killed or injured if you don’t take precautions. This is the highest level of

MC75 - WC TRUE MOLD CONTROL, WITH A NARROW BAND DESCRIPTION OF IT’S OPERATION 1 THE TRUE MOLD CONTROL is designed as a source of high temperature

MC75 - WC INSTALLATION 1. Inspect carton that the unit has been shipped in for damage. Report any damage to the carrier. NOTE: Take exception on an

MC75 - WC v After checking rotation, setting the temperature of water you need for the mold, you can now start the water pump. The unit is ready for

MC75 - WC 2. Installation 1.2 Installation, Operation and Maintenance Instructions. 1.3 Model NPE/NPE

MC75 - WC 2.3.2. Place unit in position on wedges located at four points (two below appr

MC75 - WC 6.1.1. Single-phase motor: Non-reversible. 6.1.2. Three-phase motor: Interchan

MC75 - WC 10